Individual Continuously Float Level-Sensors
Fluid fill levels can be reliably and continuously detected using a sensor. The sensors from Reed Electronics AG are designed to be used in adverse conditions and various media. Thanks to the large selection of materials and dimensions, we can find the right solution for every customer.
The cost-effective sensors are used for continuous fill-level monitoring so that the user is notified about the current fill level (on a scale of 0 to 100%) and can thus respond to an event in good time or calculate the number of process cycles.
- Customer-specific production with no minimum order quantities
- Wide range of materials
- Customer-specific electrical and mechanical connections
- Measuring grid resolution of 5 mm, 10 mm or 15 mm
- Available in an optional food design (electropolishing process)
- Available in an optional EX design
- Optional 1–2 switchpoints (full status signal and empty status signal)
- Can be combined with temperature switches or PT100 / PT1000
- Reliable
- Free from wear and tear and no maintenance required
- Simple installation
- No programming necessary
TECHNICAL SPECIFICATIONS
-
Mechanical connections
G3/8", G1/2", G1", G1.5", G2", flange
(optional incl. counter nut) -
Mechanical materials
PVC, PP, PVDF and stainless steel
-
Float materials
PVC, PP, PVDF and stainless steel
-
Float dimensions
Ø 40–52 mm
-
Tube dimensions
Ø 12–16 mm
-
Sensor length
100–2,000 mm
-
Installation types
From the inside, from the outside or an inverted installation
-
Installation position
Max. 30°
-
Section of measurements
100–2,000 mm
(dependent on the float and the grid dimensions) -
Measuring grid
5 mm, 10 mm or 15 mm
-
Electrical connections
Socket, cable, plug-in connector or as per a specific customer request
-
Socket materials
Aluminium and polyamide
-
Cable materials
PVC, PUR, silicone, Teflon, FEP or as per a specific customer request
-
Output signal
Resistance Ω, Current 4–20 mA, Voltage 0–10 V
-
Temperature range
-20°C to 120°C
(dependent on the float and the materials) -
Pressure range
Must not be used as a safety-relevant limiting device within the pressure range.
P max. upon request; the pressure range is always dependent on the float. -
Protection class
Up to IP68
-
Approvals
EX design, food (electropolishing process)
-
Assembly
Can be installed in assemblies
-
Note
Optional 1–2 switchpoints (full status signal and empty status signal)
The sensors are based on a modular design and can be assembled individually.